About Dove White Granite Tiles & Pavers
Dove White Granite Pavers with Sawn Edges are available in: 800x400mm and 500x500mm in 20mm thick, (all stocked) other sizes available by request. Thickness and size variation is the industry standard of +-2mm.
Dove White Granite Pavers with Sawn Edges are available in: 800x400mm and 500x500mm in 30mm thick, (all stocked) other sizes available by request.
Dove White Granite Pavers with Drop Face available in: 800x400mm and 500x500mm in 40/20mm thick (other sizes available by request, or we can cut down existing sizes to suit).
Stocked in 800x400mm and 500x500mm. Available in any size from 400mm x 400mm up to 2000mm x 1000mm
For matching pool coping / stone capping tiles, we also have Dove Granite in bullnose, drop face and square edge pool coping styles.
We deliver granite tiles, pavers and pool coping door to door to all suburbs in Melbourne, Sydney, Canberra, Brisbane, Adelaide and Hobart. We also deliver to any regional area in Australia at reasonable freight rates.
Find out more about granite pavers >>
Granite stone can be sealed with an invisible penetrating sealer to assist in the ongoing clean up of the stone.
An invisible penetrating sealer can be applied prior to grouting which will facilitate easy clean up after application of the grout.
Cleaning:Do not use Hydrochloric acid for clean up as this can cause minerals present in the stone to react.
Maintenance:Just sweep when needed. Granite responds well to high pressure cleaning. A solution of mild detergent and water, can be applied prior to pressure cleaning.
Installation Tips:Please ensure ALL grout lines are completely dry and the tiles are completely dry prior to applying the grout. IF you don’t you may end up with shading occuring on the tiles surface due to the trapped excessive moisture still present and then ADDED to during the grouting process. (This may disappear over a full cycle of the seasons). BUT to guarantee this doesn’t occur we would recommend NOT grouting if the tiles are damp and the grout joints contain residual water. ALSO try to use a dryer grout mix. IF unsure please ring us for FREE advice. If laying in adhesive we recommend ONLY using a rapid setting white adhesive like Mapei Granirapid White.IF laying in sand and cement please ONLY use BRITE n LITE white cement to ensure no shadowing comes through the stone from using GREY cement and you must seal the back of the tile prior to installation. PLEASE ADD Efflock ( available from Bunnings) to both the sand and cement bedding mix and the grout mix when laying in sand and cement ( Call if you need further instructions). BUT we would prefer you to use UNLTRACOLOUR PLUS grout from MAPEI for grout in both sand and cement or adhesive layed tiles. And For permanently installed tiles (using Adhesive OR Sand and Cement) the only guaranteed sustainable way to protect the stone from stains caused by rust, efflorescence, water stains migrating from the installed back of the tile from the bedding mix, is sealing with special two component coating material (e.g. AKEMI AKEPOX® 2015 Anti-Stain- Available from STONEX) or if unavailable use GRANIRAPID from Mapei. Interesting INDEPENDENT article regarding improper installation techniques and the associated long term problems, most of which we have covered above https://www.pavingexpert.com/stain_reflective_01
-
Capri Limestone White Pavers & Tiles
Shell Limestone White Pavers & Tiles
Smokey Quartz Pavers & Tiles
Dove White Drop Face Pool Coping